Safety Instructions For All Saws - Hilti SC 60W-A36 Manual Del Usuario

▶ Keep handles and grasping surfaces dry, clean and free from oil and
grease. Slippery handles and grasping surfaces do not allow for safe
handling and control of the tool in unexpected situations.
Battery tool use and care
▶ Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a risk of
fire when used with another battery pack.
▶ Use power tools only with specifically designated battery packs. Use
of any other battery packs may create a risk of injury and fire.
▶ When battery pack is not in use, keep it away from other metal
objects, like paper clips, coins, keys, nails, screws or other small
metal objects, that can make a connection from one terminal to
another. Shorting the battery terminals together may cause burns or a
fire.
▶ Under abusive conditions, liquid may be ejected from the battery;
avoid contact. If contact accidentally occurs, flush with water. If
liquid contacts eyes, additionally seek medical help. Liquid ejected
from the battery may cause irritation or burns.
▶ Do not use a battery pack or tool that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
▶ Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 265 °F may cause explosion.
▶ Follow all charging instructions and do not charge the battery pack
or tool outside the temperature range specified in the instructions.
Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
Service
▶ Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
▶ Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.

2.2 Safety instructions for all saws

Cutting procedures
DANGER: Keep hands away from cutting area and the blade. Keep
▶
your second hand on auxiliary handle or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
▶ Do not reach underneath the workpiece. The guard cannot protect you
from the blade below the workpiece.
▶ Adjust the cutting depth to the thickness of the workpiece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
2172267
*2172267*
Printed: 04.06.2018 | Doc-Nr: PUB / 5389747 / 000 / 01
English 5