Sauder Via 419613 Instrucciones De Montaje página 14

Step 10
NOTE: You can choose to fasten one or two PULLS (12K) to your KEYBOARD FRONT (D) as shown in options #1 and #2.
å
Option #1 - Continue drilling through the two holes in the KEYBOARD FRONT (D) using a 1/16" drill bit. Then from the
å
opposite surface, use a 3/16" drill bit to enlarge the holes to their proper size.
Option #2 - Continue drilling through the four holes in the KEYBOARD FRONT (D) using a 1/16" drill bit. Then from the
å
opposite surface, use a 3/16" drill bit to enlarge the holes to their proper size.
Depending on the option you choose, fasten one or two PULLS (12K) to the DRAWER FRONT (D). Use two or four BLACK
å
7/8" MACHINE SCREWS (37S).
For long-term care and maintenance of your unit, you may touch up the edges with the TOUCH-UP PEN (10M).
å
Push a HOLE PLUG (11P) into each hole in the KEYBOARD FRONT (D).
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
BLACK 7/8" MACHINE SCREW
(2 or 4 used for the PULLS)
10M
Page 14
Option #1
D
37S
Option #2
D
N
To cover the holes
12K
419613
11P
To cover the holes
www.sauder.com/services