Publicidad
14
14
Loosen screw #3 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #3.
3
The higher the screw in the oblong hole, the
higher your drawer front will be. The lower
the screw, the lower the drawer front.
To make adjustments to the drawer, loosen SCREW #3 in the SLIDES a 1/4 turn, then turn the CAM clockwise or counter-clockwise.
Notice how the drawer raises or lowers as you turn the CAM. The higher the screw in the oblong hole, the higher your drawer front
will be. The lower the screw, the lower the drawer front. By adjusting the drawer this way, it will help the DRAWER FRONT line up
better when closed. Tighten the SCREW when finished with adjustments.
Page 18
2
Cam
www.sauder.com/services
411885
Publicidad
