Publicidad
3 3
N
These edges
should be even.
Turn four BLACK 9/16" FLAT HEAD SCREWS (CC) into the ENDS (A and B) until the shoulder of the SCREWS rest on the surface
of the ENDS.
Slide the END MOLDINGS (N) onto the ENDS (A and B). Line up the groove in the MOLDINGS over the head of the SCREWS in
the ENDS.
411885
Apply pressure with your hands as
you guide the MOLDINGS over
the SCREWS and onto the ENDS.
A
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
B
Shoulder
CC
These edges
should be even.
N
Page 7
Publicidad
