Description (Fig. A) - Ferm AGM1038 Manual Del Usuario

All manuals and user guides at all-guides.com
2
Wear hearing protection.

DESCRIPtION (FIG. A)

Your angle grinder has been designed for grinding
and cutting masonry and steel.
1. On/off switch
2. Lock-off button
3. Spindle lock button
4. Spindle
5. Guard
6. Main grip
7. Auxiliary grip
8. LCD display
9. Battery connection
10. Battery release button
ASSEMBLy
3
Before assembly, always switch off the
machine and remove the battery.
Mounting and removing the guard (fig. B)
2
Do not use the machine without the
guard.
Mounting
● Place the machine on a table with the spindle
(4) facing upwards.
● Keep the spindle lock button (3) pressed and
remove the flange (11) using the flange key (12).
● If necessary, remove the grinding disc (13).
● Remove the flange (14).
● Loosen the screws (15) and remove the
mounting ring (16).
● Mount the guard (5).
● Mount the mounting ring (16) and tighten the
screws (15).
● Mount the flange (14).
● If necessary, mount the grinding disc (13).
● Keep the spindle lock button (3) pressed and
mount the flange (11) using the flange key (12).
Removing
● Place the machine on a table with the spindle
(4) facing upwards.
● Keep the spindle lock button (3) pressed and
remove the flange (11) using the flange key (12).
● If necessary, remove the grinding disc (13).
● Remove the flange (14).
● Loosen the screws (15) and remove the
mounting ring (16).
● Remove the guard (5).
8
● Mount the mounting ring (16) and tighten the
screws (15).
● Mount the flange (14).
● If necessary, mount the grinding disc (13).
● Keep the spindle lock button (3) pressed and
mount the flange (11) using the flange key
(12).
Mounting and removing the grinding disc
(fig. B)
2
Do not use the machine without the
guard.
Mounting
● Place the machine on a table with the guard (5)
facing upwards.
● Keep the spindle lock button (3) pressed and
remove the flange (11) using the flange key (12).
● Mount the grinding disc (13).
● Keep the spindle lock button (3) pressed and
mount the flange (11) using the flange key (12).
Removing
● Place the machine on a table with the guard
(5) facing upwards.
● Keep the spindle lock button (3) pressed and
remove the flange (11) using the flange key (12).
● Remove the grinding disc (13).
● Keep the spindle lock button (3) pressed and
mount the flange (11) using the flange key (12).
Mounting and removing the auxiliary grip
(fig. C)
Mounting
● Tighten the auxiliary grip (7) into one of the
mounting holes (17).
Removing
● Loosen the auxiliary grip (7) from the mounting
hole (17).
Mounting and removing the battery (fig. D)
The machine must be used with one of the
following batteries:
- 18V Li-Ion battery (CDA1051)
- 18V NiMH battery (CDA1053)
● To mount the battery, insert the battery (18)
into the battery connection (9).
● To remove the battery, keep the battery
release buttons (10) pressed and remove the
battery (18) from the battery connection (9).