Product Description - Nice MINDY A60 Instrucciones Y Advertencias Para La Instalación Y El Uso

2) Product description

This control unit for the automation of gates and doors enables control of two gearmotors with single-phase alternating current.
The unit features a series of Dip-switches (mini switches) that enable the selection of the various functions, as well as trimmers used for
making adjustments.
The status of the inputs is signalled by LED's located next to the inputs. An additional LED located near the microprocessor indicates whether
the internal logic is operating properly.
To facilitate part identification, Fig.1 below shows the most significant components.
1
1 Transformer
2 Low voltage fuse (500 mA F)
3
Force adjustment trimmer (F)
4 Pause Time adjustment trimmer (TP)
5 Opening Time Delay adjustment trimmer (TRA)
6
Motor 1 Working Time adjustment trimmer (TL1)
7 Motor 2 Working Time adjustment trimmer (TL2)
8 Closing Time Delay adjustment trimmer (TRC)
9 Manoeuvre balance trimmer (BAL)
10 Terminal board for aerial
11 Led OK
12 Radio slot connector
13
Step-by-step button
14 Function selection Dip-Switch
15 Microprocessor
4
All manuals and user guides at all-guides.com
16
17
18
19
20
21
22
23
24
25
26
27
28
29
Electric lock relay
Common motor relay
Courtesy light relay
Open / Close movement direction relay
Phototest relayt
Motor 2 Triac
Motor 1 Triac
Rapid fuse (5A 230Vac) or (6.3A 120Vac) power
Input / output control terminal board
Motor outputs terminal board
Flashing / C.tsy light output terminal board
Power supply terminal board
Motors ON LED
Jumper for selection of deceleration mode (M-RAL)