Troubleshooting
DANGER
First pull out the plug from the mains before carrying out
any tasks on the machine.
Suction turbine does not run
Check the receptacle and the fuse of the power
supply.
Check the power cable, the power plug and the
thermal probe of the device.
Turn on the appliance.
Suction turbine turns off
Empty the container.
Check whether the protective cover is available
and the side opening of the protective cover points
to the right placement mechanics (see illustration of
appliance).
Clean the thermal probe and the protective cover
with a moist cloth.
Suction turbine does not start again after the
container has been emptied
Turn the appliance off and back on.
Clean the thermal probe and the protective cover
with a moist cloth.
Suction capacity decreases
Remove blockages in the suction nozzle, suction
tube, suction hose, or flat pleated filter.
Check the suction head and the receptacle for
proper seating.
Ensure the filter cover properly locks into place.
Replace the flat pleated filter.
Dust comes out while vacuuming
Check for proper installation of the flat pleated filter.
Replace the flat pleated filter.
Automatic shut-off (wet vacuum cleaning)
does not react
Clean the thermal probe and the protective cover
with a moist cloth.
Automatic filter cleaning is not working
Suction hose is not connected.
Suction hose used is too short (< 3m) or the diam-
eter is too large.
Inform Customer Service.
Automatic filter cleaning cannot be switched
Inform Customer Service.
The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service center.
Please submit the proof of purchase.
10
off
Warranty
Accessories and Spare Parts
Only use original accessories and spare parts, they en-
sure the safe and trouble-free operation of the device.
For information about accessories and spare parts,
please visit www.kaercher.com.
–
Accessories are not included in the delivery. The
accessories for the device must be ordered sepa-
rately, depending on the application.
–
The device's correct function is only ensured when
using suction hose nominal widths of DN40 and
DN50.
–
You can procure the spare parts and the attach-
ments from your dealer or your KÄRCHER branch
office.
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements of the EU Directives, both in its basic design
and construction as well as in the version put into circu-
lation by us. This declaration shall cease to be valid if
the machine is modified without our prior approval.
Product:
Type:
Relevant EU Directives
2006/42/EC (+2009/127/EC)
2011/65/EU
2014/30/EU
Applied harmonized standards
EN 55014–1: 2017 + A11: 2020
EN 55014–2: 2015
EN 60335–1
EN 60335–2–69
EN IEC 61000–3–2: 2019
EN 61000–3–3: 2013 + A1: 2019
EN 62233: 2008
EN IEC 63000: 2018
Applied national standards
-
5.966-010
The undersigned act on behalf and under the power of
attorney of the company management.
Managing Partner
M. Pfister
Kärcher Industrial Vacuuming GmbH
Robert-Bosch-Straße 4-8
73550 Waldstetten (Germany)
Phone: +49 7171 94888-0
Fax: +49 7171 94888-528
Waldstetten, 2021/11/04
– 3
EN
Wet and dry vacuum cleaner
1.576-xxx