Rear Panel - Optimus MAV-120Z6 Manual De Instalación Y Funcionamiento

4. BUSY indicator
It lights green if the microphone is disabled due to higher priority signal.
5. Speaker zone 1‐6 indicator
Green when zone is in use, either by PMV‐6Z or any amplifier input.
Blinking green when zone is selected for paging.
6. Speaker zone 1‐6 selector
7. CALL button
Press to talk, release to end the call.
8. All zone selector
5.3. REAR PANEL
9. POWER switch
10. RJ45 port to cascade another remote microphone
11. RJ45 port to communicate with the amplifier
12. Microphone volume control
It affects the microphone only; chime is not affected.
13. AUX input
Line input 0 dB. Jack stereo 3.5 mm. When connecting the Jack, it replaces the gooseneck mic
input.
14. Settings dipswitch
SW 1‐4: Use to set the microphone ID. From 1 to 8 in binary format.
SW 5‐7: Use to set microphone priority. From 0 to 7 in binary format. 0 is maximum priority.
Two simultaneous calls with same priority behave as FIFO.
SW 8: Indication test. Set to activate all LED and check they light correctly.
MAV SERIES Version 1.0
MAV SERIES
AMPLIFIER
Page 7 of 13