Starting Your Air Conditioner - Hisense 12K BTU Instrucciones De Instalacion Y Uso

Timer Sleep Filter Timer Sleep Filter
CONNECT CONNECT
ON/OFF
1. Press the power button to turn on the air conditioner.
ON/OFF
NOTE: When the air conditioner is turned on for the first time
after it is plugged in, the display will show the current set
temperature and will run in the ECO control .
After cleaning and replacing the filter, press the POWER
button for resetting and the FILTER light will go off.
2. Select mode. See "Mode".
3. Select fan speed. See "Fan".
4. Set temperature. See "T emperature ".
Mode
1. Press MODE repeatedly until you see the indicator light glow
for the desired setting.
2. Choose Fan, Dry, Cool, Eco, or Heat.
FAN - To select Fan Only mode.
■
Dry - Dries the room. The air conditioner automatically
■
selects the temperature. Fan runs at Low speed only.
Cool - Cools the room.
■
Eco - Cools the room and save energy.
■
Heat - Heats the room.
■
NOTE: Heat is available only for heating models.
NOTE: Dry mode should not be used to cool the room.
NOTE: Select ECO mode to initiate this function.
For E-star models,the fan will continue to run after
the compressor shuts off for 2 minutes(4minutes
for the first time),then the fan will shuts off for 10
minutes .The fan then cycles run for 2 minutes
and 10 minutes off intervals until the room
temperature is above the set temperature,at which
time the compressor turns back on and Cooling
resumes.
Dry Dry
Fan Fan
MODE MODE

Starting Your Air Conditioner

High High
Low Low Med Med
FAN FAN
Cool Cool
Eco Eco Heat
T emperature
Press the plus UP
■
time you press or hold the plus
temperature will go up 1°F (1°C) until it reaches 86°F (30°C).
Press the minus DOWN (
■
time you press or hold the DOWN (
will go down 1°F (1°C) until it reaches 61°F (16°C).
To change the temperature display from °F to °C:
Press both the MODE and DOWN (
time for 5 seconds to switch the display from °F to °C.
Fan
NOTE: The Fan button will operate only when the Cool,Fan,ECO
or heat mode has been selected.
1. Press FAN until you see the indicator light glow for
the desired setting.
2. Choose High, Med, Low.
High - for maximum cooling
■
Med - for normal cooling
■
Low - for quieter cooling
■
NOTE : In ECO mode,the Fan will run at low
speed when compressor turn off.
11
Dry Dry
Fan Fan Cool Cool Eco Eco Heat
MODE MODE
∧
( )
button to raise the temperature. Each
∧
UP ( )
button, the
∨
) button to lower the temperature. Each
∨
) button, the temperature
∨
) buttons at the same
High High
Low Low Med Med
FAN FAN
■
ON/OFF