Manual Lighting Procedure; Shutting Off Your Griddle - Pit Boss ULTIMATE GRIDDLE PB2BGD2 Manual Del Propietário

Plancha con parte superior extraíble, plancha con gabinete
Ocultar thumbs Ver también para ULTIMATE GRIDDLE PB2BGD2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MANUAL LIGHTING PROCEDURE

1.
Open lid during lighting.
2. Set all control knobs to the "O" position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Quickly and carefully, use a lit match secured with the lighting
rod (included with the grill) to light the burner. Gain access
to the burner from beneath the Hot Plate. Position lit match
near the side of the burner.
CAUTION: Do not attempt to light another area of the
burner. This can cause injury.
5. Push and turn the burner control knob counter-clockwise to
"
(light position)", hold this knob in for 10 seconds after the
burner is lit. You will hear the "snapping" sound of the spark
until after the knob is released.
NOTE: Do not use spirit, lighter-fluid or kerosene for
lighting or refreshing a fire in your griddle.
6. If the burner does not light within 5 seconds, turn burner control knob to "O", wait 5 minutes, and repeat lighting instruction.
After lighting, observe the burner flame. Make sure all burner ports are lit and flame height matches illustration shown
previously.
NOTE: Each burner lights independently - repeat same steps for other burners.
WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your grill by match.
If the above points do not work, see Troubleshooting.
7.

SHUTTING OFF YOUR GRIDDLE

1.
When finished cooking, turn gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This safety
feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn control knobs to the "O" position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect gas supply by following the Disconnect A Gas Cylinder instructions.
WARNING: Allow the griddle to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido