Instruction Manual - GRAPHITE 59G262 Instrucciones De Uso

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
NOTE: BEFORE THE POWER TOOL IS USED FOR THE FIRST TIME, READ THIS INSTRUCTION MANUAL AND
KEEP IT FOR FUTURE REFERENCE.
Before connecting to the power source, always make sure the supply voltage is compatible with the
value specified on the nameplate of the tool.
The sander can be connected only to an electrical system equipped with a differential current protection
that will cut the power off when earth leakage current exceeds 30 mA in less than 30 ms.
A dust extraction system must be connected to the sander.
Before the sander is switched on, make sure the sanding paper is securely fastened to the working disc
and it does not touch the workpiece.
The sander should be held firmly during operation.
Do not touch sander parts that are in motion.
Use a dust mask and safety glasses fitting tightly to the face. Plaster dust produced when sanding
plaster surfaces is harmful to health.
Bystanders should not enter the room, in which plaster surfaces are sanded using the sander. Do not
eat or drink in such a room.
Do not use the sander for wet sanding.
The power cord should be always kept away from moving parts of the sander.
Immediately disconnect the power, if the power cord is damaged during operation. DO NOT TOUCH
THE POWER CORD, BEFORE THE POWER IS DISCONNECTED.
WARNING: When the motor is switched off, the working disc keeps on turning.
Keep the unwound power cord away from the working disc.
Do not allow the sander to be operated by children and people not familiarized with the instruction
manual.
REMEMBER: The operator or user is responsible for accidents or hazards occurring to other people or
the environment.
Pull the plug out of the socket:
- every time you walk away from the tool;
- before the tool is inspected, cleaned or repaired;
The sander should be repaired by authorised people only.
Only spare parts recommended by the manufacturer should be used.
MAINTENANCE AND STORAGE
All components should be kept in the proper condition to be sure the sander will operate safely.
Worn or damaged parts should be replaced to maintain safety.
The sander should be protected against moisture.
Keep out of reach of children.
Use sanding paper of proper type.
NOTE! The tool is intended for indoor works.
Despite using the construction, which is safe by design itself, protection means and additional safety
features, there is always a residual risk of injuries during operation.
DESCRIPTIONS OF USED PICTOGRAMS.
PLASTER SANDER
59G262
DETAILED SAFETY REGULATIONS
13
9