GRAPHITE 59G262 Instrucciones De Uso página 15

ATTACHING THE ADDITIONAL HANDLE
It is recommended to use the additional handle for the sander. The additional handle (8) is installed in one
of the holes in the sander housing (fig. A). If the sander is held with both hands during operation (also using
the additional handle), the risk of losing control of the tool is much lower.
FASTENING THE SANDING PAPER
The sander has a working disc with the so called Velcro, which allows for an easy and quick replacement of
the sanding paper.
Move the sanding paper to the working disc (10) so that its holes „a" coincide with the holes of the
working disc and press it to ensure efficient dust extraction (fig. B).
In order to remove the sanding paper, just peel it from one side, and then pull it all the way (fig. C).
Use perforated sanding paper, so that dust can escape through the holes in the working disc to a
dust extraction system. Each time the sanding paper is replaced, clean the working disc removing all
dust and dirt using a brush.
DUST EXTRACTION
Insert the suction hose end onto the duct extraction connector (4) (fig. D).
Connect the other end of the suction hose to a dust extraction system, such as a dust bag or workshop
vacuum cleaner.
Set proper suction force by turning the suction adjustment dial (7) counter-clockwise or clockwise
(fig. E).
FITTING AND ADJUSTING THE ARM BELT
Switch off the sander motor, when fitting or adjusting the arm belt.
The proper adjustment of the arm belt can facilitate operation to a great extent. The arm belt is especially
useful when working at a height.
Put the snap-hooks in the hooks of the arm belt (1).
Adjust the length using the arm belt buckle (fig. F).
The mains voltage must correspond to the value specified on the sander nameplate.
Switching on - press the switch button (6).
Switching off - release the pressure on the switch button (6).
The switch lock (continuous operation)
Switching on:
Press the switch button (6) and hold it in this position.
Press the switch lock button (5) (fig. G).
Release the pressure on the switch button (6).
Switching off:
Press and release the pressure on the switch button (6).
SPEED ADJUSTMENT
The speed adjustment dial is located on the sander housing (3). The speed is selected according to the
needs (depending on sanding paper used, workpiece hardness, type of work, etc.). Rotate the speed
adjustment dial (3) to increase or decrease the working disc speed (fig. H).
WORKING WITH THE SANDER
Sanded surfaces should be dry, free of foreign bodies, such as screws, nails, bolts, etc.
The sander should be held firmly with both hands.
PREPARATION FOR WORK
OPERATION / ADJUSTMENTS
15