Adjustment Of Wind Direction - Toshiba RAV-SM402MUT-E Manual Del Propietário

7

ADJUSTMENT OF WIND DIRECTION

• Be sure to draw a line about the use of the louver between cooling and heating operation in order to increase
the cooling/heating effect.
• When the air conditioner stops, the louver (adjustment plate of up/down wind direction) close automatically.
• In heating operation, when starting the operation/executing defrost operation or when the room temperature has
reached the set temperature, the fan stops or the wind volume becomes less extremely and the louver directs
upward.
• In this time, if you set the swinging operation or the wind direction, the setup contents are displayed on the
remote controller but the louver does not move as it directs upward.
• When starting the usual heating operation which blows hot air, the louver directs toward the setup wind direction.
How to set up the wind direction
1
SWING/FIX
Push during operation.
The wind direction changes for every push of the
button.
In HEAT operation
Direct the louver (adjustment plate of up/down wind
direction) downward.
If directing at horizontally, hot air
may not come to the foot.
In COOL/DRY operation
Direct the louver (adjustment plate of up/down wind
direction) horizontally.
If directing it downward, the dew
may from on the surface of the
air discharge port and may drop down.
In FAN operation
Select a desired wind direction.
How to start swinging
1
SWING/FIX
Push , set the louver (adjustment plate
of up/down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up/down wind
direction is automatically selected.
Display during swinging
Repeat
English-9
All manuals and user guides at all-guides.com
Initial setup
Initial setup
Initial setup
SWING/FIX
again.
9
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
How to stop swinging
1
SWING/FIX
Push at a desired position while the
louver is swinging.
SWING/FIX
• When is pushed after that, wind direction
can be set again from the highest position.
SWING/FIX
∗ However, even if
is swinging, the louver position is displayed as
follows and highest position of the louver may not
be selected.
Display when swinging is stopped
FAN/HEAT
operation
SWING/FIX
In this case, push
• In COOL/DRY operation, the louver does not stop
as it directs downward.
If stopping the louver as it directs downward
during swing operation, it stops after moving to
the third position from the highest position.
Display when stopping the swing
FAN/HEAT
operation
ON / OFF
FAN MODE
SAVE VENT
SWING/FIX UNIT LOUVER
1
is pushed while the louver
COOL/DRY
operation
again two seconds later.
COOL/DRY
operation