Correct Usage - Toshiba RAV-SM402MUT-E Manual Del Propietário

5

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the procedure below.
From the next time, the operation displayed on the remote controller will start by pushing the
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
∗ After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but
it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
and the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the leakage breaker at
least 12 hours before starting operation.
Start
1
ON / OFF
Push button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the
MODE
"MODE " button.
One push of the button, and the display changes in
the order shown as follows.
3
Select air volume with "
One push of the button, and the display changes in the order shown as follows.
• When air volume is "
according to the room temperature.
• In heating operation, if the room temperature is not
heated sufficiently with VOLUME "
operation, select "
• The temperature sensor senses temperature near the suction air port of the indoor unit, which differs from the
room temperature depending on the installation condition.
A value of setting temperature is the measure of room temperature.
(" AUTO" is not selectable in the FAN mode.)
4
Determine the set up temperature by pushing the "TEMP.
Stop
ON / OFF
Push button.
The operation lamp goes off, and the operation stops.
English-7
All manuals and user guides at all-guides.com
TEMP.
4
TIMER SET
TIME
FILTER
RESET TEST SET
FAN
" button.
AUTO", air volume differs
LOW"
MED." or " HIGH" operation.
ON / OFF
button without turning off the main power switch
ON / OFF
3
FAN MODE
SAVE VENT
CL SWING/FIX UNIT LOUVER
AUTO HEAT
AUTO
" or "TEMP.
7
ON / OFF
button only.
1
2
DRY COOL FAN
HIGH MED. LOW
" button.