Küschall COMPACTattract Manual Del Usuario página 38

Compact attract
Visual check
1. Examine your wheelchair for loose parts, cracks or other
defects.
2. If you find anything, have your wheelchair checked
immediately by a specialist dealer.
Clean the front wheels
1. Check that the front wheels turn freely.
2. Remove any dirt or hair from the front wheel bearings.
Check the bolts
Bolts can work loose through constant use.
1. Check that the bolts are tight (on the footrest, seat cover,
sides, backrest, frame, seat module).
2. Tighten any loose bolts with the suitable torque. Therefore
refer to the Service Manual küschall Compact
on the internet at www.kuschall.com.
IMPORTANT!
Safety nuts and bolts lose their effectiveness as a
result of repeated loosening and tightening.
– Safety nuts and bolts must be replaced by a
specialist dealer.
Check the spoke tension
The spokes should not be loose or distorted.
1. Loose spokes must be tightened by a specialist dealer.
2. Broken spokes must be replaced by a specialist dealer.
38
All manuals and user guides at all-guides.com
Check the parking brakes
1.
2. If you find that the setting is not correct, have the brakes
Checking after a heavy collision or blow
, available
attract
Repairing or changing an inner tube
1.
2. Lift one tire wall away from the rim using a bicycle tire lever.
3. Pull the inner tube out of the tire.
4. Repair the inner tube using a bicycle repair kit or, if necessary,
5. Inflate the tube slightly until it becomes round.
6. Insert the valve into the valve hole on the rim and place the
Check that the parking brakes are positioned correctly. The
brake is set correctly if the brake shoe depresses the tire by a
few millimetres when the brake is applied.
correctly set by a specialist dealer.
IMPORTANT!
The parking brakes must be reset after replacing
the rear wheels or changing their position.
IMPORTANT!
The wheelchair can sustain visibly undetectable
damage as a result of a heavy collision or hard
blow.
– It is essential to have your wheelchair checked
by a specialist dealer after a heavy collision or
hard blow.
Remove the rear wheel and release any air from the inner
tube.
Do not use sharp objects such as a screwdriver which could
damage the inner tube.
replace the tube.
tube inside the tire (the tube should lie right round the tire
with no creases).
1589081-A