Operating/Programming Operation Mode K2 - Wittkopp SmartCam Manual De Uso

6 Operating/programming operation mode K2

6.1 Locking K2
Close the door at the safe and enter any key.
1.
Turn the knob within 3 seconds into locking position. The lock is closed.
6.2 Opening
6.2.1 Opening with user code
1. Enter your 4-/6-digit code e.g. user code.
Turn the knob within 3 seconds into opening position.
2.
The lock is opened.
6.2.2 Opening with master code K2
Press and hold the key "8" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter your 6-digit master code e.g.
Turn the knob within 3 seconds into opening position.
3.
The lock is opened.
• After a wrong code input a long signal tone occurs and the red LED flashes.
• After 4 consecutive wrong code inputs, a blocking time of 1 minute occurs. During this blocking time the red LED flashes
every 10 seconds. It is not possible to insert a code during the blocking time is active. After the blocking time expires the red
LED stops flashing. After the blocking time has passed 2 further incorrect inputs will restart the blocking time of 1 minute.
6.2.3 Changing the user code K2
Press and hold the key "0" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter the following digit for the type of change.
3. Enter your 6-digit master code or your 4-/6-digit user code e.g. user.
4. Enter your new 4-/6-digit user code e.g.
5. R-enter your new 4-/6-digit user code e.g.
6. The new user code is accepted.
10
3333 / 33
8
123456
0
0
by the master or
1
by the user
4444 / 44
1111 / 11
1111 / 11
SmartCam
 
 
 
 
Rel. 1.2