Operating/Programming Operation Mode K1 - Wittkopp SmartCam Manual De Uso

5 Operating/programming operation mode K1

5.1 Locking K1
Close the door at the safe and enter any key.
1.
Turn the knob within 3 seconds into locking position. The lock is closed.
5.2 Opening K1
5.2.1 Opening with user code K1
1. Enter your 4-/6-digit code e.g. user code.
Turn the knob within 3 seconds into opening position.
2.
The lock is opened.
5.2.2 Opening with master code/administrator code K1
Press and hold the key "8" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter your 6-digit master code e.g.
Turn the knob within 3 seconds into opening position.
3.
The lock is opened.
• After a wrong code input a long signal tone occurs and the red LED flashes.
• After 4 consecutive wrong code inputs, a blocking time of 1 minute occurs. During this blocking time the red LED flashes
every 10 seconds. It is not possible to insert a code during the blocking time is active. After the blocking time expires the
red LED stops flashing. After the blocking time has passed 2 further incorrect inputs will restart the blocking time of 1 minute.
5.3 Programming a user code K1
The administrator is able to program a user code, but not vice versa.
All 9 users are assigned the PIN numbers 0-8.
Press and hold the key "1" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter your 6-digit administrator code e.g.
3. Enter the user PIN e.g. user 1.
4. Enter your 4-/6-digit user code e.g.
5. Re-enter your 4-/6-digit user code e.g.
6. The user code is accepted.
6
3333 / 33
8
123456
1
654321
1
1111 / 11
1111 / 11
SmartCam
 
 
 
 
Rel. 1.2