Power Supply And Battery Change - Wittkopp SmartCam Manual De Uso

SmartCam

13 Power supply and battery change

• The lock is power supplied by one 9 V block battery alkaline (no rechargeable batteries!). When battery voltage is insufficient,
after entering the code a warning tone occurs repeatedly and the red LED flashes alternately. Change the battery as quickly
as possible. The programmed codes stay valid during battery change.
• With fixed battery comapartment:
If the battery should be as empty that no more code can be entered and opening of the safe becomes impossible, the lock
can be powered from the outside. Remove the foil at the given points (fig. 1). Hold a 9 V block battery onto the contacts of
the input unit and open the lock as described.
• Always dispose used batteries in an environmentally friendly way.
Fig. 1: Battery compartment SmartCam and emergency powering contacts
Rel. 1.2
In order to change battery loosen screw and
slide out battery compartment
Cut foil and remove. Hold battery here
15