General Instructions; Operating Notes - Wittkopp SmartCam Manual De Uso

1 General instructions

• Please read the operating instructions carefully, before activating the lock.
1.1 Liability notes
• We don't assume liability for malfunctions due to incorrect operation, use of force or inappropriate handling. In cases of
damage to property or valuables, which are due to incorrect locking of the safe, we also don't assume liability.
• If your safe, however, does not open correctly with the following instructions, please contact the manufacturer of the safe.

1.2 Operating notes

• If the lock is not opened or closed within 10 seconds after entering the code or entering the menu sequence, the electronics
switch off. The old code remains active.
• Every correct input when opening/programming is confirmed by an acoustic signal and flashing of the red LED.
These signals will not be considered in this instruction.
• Operation mode K1: All 9 users are assigned the PIN numbers 0-8.
• Never use force.
• Do not open the lock case, otherwise you compromise the function of the lock and warranty will be void.
1.3 Notes on safety
• For your security, change the factory codes immediately.
• For your new code, do not use any personal data like birthdays or any other data, which could be known by knowledge of
your person.
• After entering the new code, the electronic lock should be opened and locked several times with the safe door opened.
• After each locking doublecheck if the safe is closed.
1.4 Factory mode
• Upon delivery the lock is factory setted on opertion mode K1/number 10:
• The initial factory codes are:
- Master factory code: 1-2-3-4-5-6 (valid for all operation modes)
- Administrator factory code: 6-5-4-3-2-1 (valid for all operation mode K1)
- Facility-master factory code: 6-5-4-3-2-1 (valid for all operation mode K3)
- User factory code: 1-1-1-1/-1-1 (valid for all operation mode K2)
Operation Number
mode
K1 10
K1 11
K2 20
K2 21
K3 30
K3 31
K4 40
K4 41
2
User codes Master codes
- number/digits - number/digits
9/4-digit 1/6-digit
9/6-digit 1/6-digit
1/4-digit 1/6-digit
1/6-digit 1/6-digit
1/4-digit 1/6-digit
1/6-digit 1/6-digit
1/4-digit 1/6-digit
1/6-digit 1/6-digit
Administrator codes Facility-master
- number/digits codes
- number/digits
1/6-digit
1/6-digit
1/6-digit
1/6-digit
SmartCam
Rel. 1.2