Tabla de contenido
Publicidad
9-13 Valid for all operating modes
9 Reset
In a case of a reset all user codes will be reset to factory mode. Programmed user codes will be deleted.
Reset is only possible when the lock is opened.
Press and hold the key "6" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter your 6-digit master code.
3. Enter the 2-digit reset code.
4. Re-enter your 6-digit master code e.g.
5. Re-enter the 2-digit reset code.
6. The lock is conditioned back in the delivery status.
10 Testing the system
Press every number once. A functional key will be confirmed by a double signal. A key that was not identi-
fied is confirmed by a long signal and the functional test is aborted. The lock has to be checked.
Press and hold the key "5" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Press every key in its order of appearance.
11 Bolt position signalisation
1. Press and hold the key "4" for eg. 3 seconds.
2. Bolt is in locking position.
3. Bolt is in opening position.
12 Reading out operation mode
The current operation mode is indicated.
Press and hold the key "7" for eg. 3 seconds.
1.
When releasing the key the green LED flashes permanently.
2. Enter your 6-digit master code e.g.
Decade = number of beeps + red LED
3.
Pause + flash red LED
Unit digit = number of beeps + green LED + red LED
4. The signalisation is completed.
14
6
123456
00
123456
00
5
1
2
3
0
,
,
...,
4
Green LED flashes
Red LED flashes
7
123456
SmartCam
Rel. 1.2
Publicidad
Capítulos
Tabla de contenido
