About Your New Label Maker
With the DYMO LabelManager 500TS label maker, you
can create a wide variety of high-quality, self-adhesive
labels. You can choose to print your labels in many
different font sizes and styles. The label maker uses
DYMO D1 label cassettes in widths of 6 mm (1/4"),
9 mm (3/8"), 12 mm (1/2"), 19 mm (3/4"), or 24 mm (1").
Labels are available in a wide range of colors.
Visit www.dymo.com for information on obtaining labels
and accessories for your label maker.
Registering Your Label Maker
Visit www.dymo.com/register to register your label
maker online.
During the registration process, you will need the serial
number, which is located inside the back cover of the
label maker.
Getting Started
Follow the instructions in this section to set up your
label maker.
Connecting the Power
The label maker is powered by a rechargeable, Lithium
Polymer (LiPo) battery pack.
Inserting the Battery Pack
The battery pack included with your label maker comes
partially charged.
Make sure the charging adapter is disconnected
before handling the LiPo battery pack.
To insert the battery pack
Lift the back cover of the
1
label maker.
Insert the battery pack into
2
the battery compartment
as shown.
Close the back cover of
3
the label maker.
Make sure to read the
LiPo Safety Precautions on page 19.
Removing the Battery Pack
Remove the battery pack when the label maker will not be
used for a long period of time.
Make sure the charging adapter is disconnected
before handling the LiPo battery pack.
To remove the battery pack
Unplug the charging adapter.
1
Lift the back cover of the label maker.
2
Remove the battery pack from the battery
3
compartment.
Make sure to read the LiPo Safety Precautions on
page 19.
Charging the Battery Pack
Use the charging adapter included with your label maker
to recharge the battery pack. Charging the battery pack
will take approximately three hours.
The charging adapter is only used for recharging the
battery pack.
To recharge the battery pack
Turn the label
1
maker over.
Plug the charging
2
adapter into the power
connector at the top
of the label maker.
Plug the other end of
3
the charging adapter
into a power outlet.
Make sure to read the LiPo Safety Precautions found
on page 19.
Inserting the Label Cassette
Your label maker uses DYMO D1 label cassettes.
To insert the label cassette
Lift the back cover
1
of the label maker to
open the label
compartment.
Make sure the tape
2
and ribbon are taut
across the mouth of
the cassette and
that the tape passes
between the
label guides.
If necessary, turn
the ribbon rewind
spool clockwise to
tighten the ribbon.
Insert the cassette
3
and press firmly until
the cassette clicks
into place.
Close the back
4
cover of the label maker.
6
Ribbon
rewind spool
Label
guides