Care And Maintenance - Kobalt SGY-AIR185 Manual Del Usuario

OPERATING INSTRUCTIONS
3.To loosen or remove a threaded fastener,
turn the switch (D) to the left until it clicks
into place. Place the socket over the
threaded fastener on the workpiece,
apply pressure and press trigger (C).
The anvil (B) will spin counterclockwise to
loosen the threaded fastener up.
WARNING:
Always make sure the
workpiece is secure. Never run the tool off
the workpiece. Do not apply excessive
force to the tool; let the tool perform the
work.

CARE AND MAINTENANCE

ALWAYS DISCONNECT TOOL FROM THE AIR SUPPLY BEFORE
PERFORMING ANY MAINTENANCE ON THE TOOL.
Always make sure the tool is properly lubricated during operation. Proper
lubrication is shown in this instruction manual.
An in-line oiler (not included) is recommended to help increase tool life and
keep the tool properly lubricated. The in-line oiler should be regularly
checked and filled with air tool oil as needed. Proper adjustment of the in-line
oiler can be performed by placing a sheet of paper next to the tool's exhaust
ports while holding the throttle completely open for 30 seconds. When a light
stain of oil collects on the paper, the oiler is properly adjusted. Excessive
amounts of oil should be avoided.
Clean the entire tool with a cotton rag after each use. If storing the tool for an
extended period, it should be lubricated and run for approximately 30
seconds to ensure oil has been evenly distributed throughout the tool. Always
store tools in a clean, dry environment away from the reach of children.
Recommended lubricants: air-tool oil or any other high-grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agents and an
EP (Extreme Pressure) additive. Consult your local retailer for further
assistance in selecting air tool oil best suited for proper lubrication.
STORAGE:
Tool must be well cleaned and lightly lubricated before storing.
Store tool in a dry, safe place out of the reach of children.
All manuals and user guides at all-guides.com
14
3
B
D
C
kobalttools.com