Care And Maintenance - Kobalt SGY-AIR141 Manual De Instrucciones

OPERATING INSTRUCTIONS
4
NOTE This tool also features a grease cap (F)
on the protector cover. Remove the screw in the
grease cap (F) with a hex key (not provided).
Use a grease gun (not provided) and insert the
gun nozzle into the grease cap (F). Several
drops of grease are recommended for lubricating
the internal hammer assembly. This will help the
hammer assembly to work in good condition and
extend tool life. Lubricate the hammer assembly
once every working day. (See Figure 4)

CARE AND MAINTENANCE

An in-line oiler is recommended to be installed on air supply line as it increases tool
life and keeps the tool in sustained operation. The in-line oiler should be regularly
checked and filled with air-tool oil. Proper adjustment of the in-line oiler is performed
by placing a sheet of paper next to the tool's exhaust ports and holding the throttle
open approximately 30 seconds. The in-line oiler is properly set when a light stain of
oil collects on the paper. Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for an extended period of
time, it should receive a generous amount of lubrication at that time. The tool should
be run for approximately 30 seconds to ensure oil has been evenly distributed
throughout the tool. The tool should be stored in a clean and dry environment.
Recommended lubricants: use air-tool oil or any other high-grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agents and an EP
(extreme pressure) additive.
Clean the tool all over with a cotton rag after each use. Keep the tool in a dry and
safe place out of reach of children.
12