3.2 Choose Your Suction Option
DEEBOT D83 has 2 interchangeable suction options for your convenience.
Function
Notes
To Remove the Main
Brush Option or the
Direct Suction Option
To Install the Main
Brush Option or the
Direct Suction Option
3.3 Power ON/Pause/Power OFF/Start
Power ON
Pause
1. Pause the robot by pressing the START/PAUSE key
or by lifting the unit off of the floor.
2. Press the START/PAUSE key
resume work.
Power OFF
After pausing work, turn OFF the power switch at the
bottom of the robot.
Note:When the robot is not working, it is suggested
to keep it charging instead of powered OFF.
All manuals and user guides at all-guides.com
Main Brush Option
The best choice for deep cleaning with a
combination of the Main Brush and strong
suction.
Install Main Brush Option (pre-installed)
Turn the robot over. Push both
Suction Option component will pop out Remove or insert the Main Brush.
Line up the Suction Option component tabs with the slots on the bottom of the robot.
Press until the component clicks into place.
Turn ON the power
switch on the bottom
of the robot.
, and the robot will
Direct Suction Option
The best choice for daily cleaning with the
Main Brush removed for direct suction.
This option avoids hair tangling around the
Main Brush, and is ideal for cleaning up pet hair.
Install Direct Suction Option
buttons below suction inlet at the same time, and the
Start
* In addition to pushing the START/PAUSE key
Cleaning, you can choose any Cleaning Mode by pushing the
corresponding key directly on control panel of the robot (for D83
ONLY) or on the Remote Control (for D80 and D83), then push START/
PAUSE key
to begin. See section 3.4 for Cleaning Mode details.
Spot Cleaning Mode
Intensive Cleaning Mode
EN
Press the START/PAUSE
key
on the robot to begin
cleaning immediately in
Automatic Cleaning Mode.
To schedule a cleaning time
in the future, please see
section 3.5 in this Instruction
Manual.
to begin Automatic
Edge Cleaning Mode
Return to Charger Mode
10