Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.2
Brewing tea
Hints and tips:
Thanks to the practical tea strainer (14) you do not need paper filters with this
appliance.
Your tea will taste best when the appliance is clean. Clean it regularly as described in
chapter 7.
Do not reuse tealeaves a second time, as this will greatly impair the flavour of your tea.
1. Take the lid of the tea strainer with the push rod (17) out of the tea pot (13).
2. Put either tealeaves or tea bags in the tea strainer (14).
3. Boil fresh water with the water boiler (1) as described above.
4. Pour the boiling water into the glass pot.
NOTE: Always be careful while handling hot water, in order to avoid personal
injuries.
5. Replace the lid of the tea strainer with the push rod (17) on the glass tea pot (13).
6. When the tea has brewed for long enough, press the push rod (17) down. Depending
on the amount, most of the tealeaves are now packed in the bottom part of the tea
strainer (14) and no longer give any flavour to the tea.
ATTENTION: Never cool the hot glass tea pot (13) down with cold water.
6.3
Keeping tea warm
Hints and tips:
You can programme the amount of time the tea is kept warm with the control panel
of the keep warm plate (10). The maximum time is three hours.
You can operate the keep warm plate (12) at three different temperature levels. The
tea is then kept warm in the glass pot according to the following settings
Your operating steps are acknowledged each time with an acoustic signal (beep).
Never use the glass pot to heat or boil cold water or other cold liquids. Only use the
water kettle (1) to heat or boil cold water.
1. Press the temperature / time setting button . The time setting in the display (19)
flashes.
2. Set the desired keep warm time with the buttons
the time by one minute, if you hold down the button, the time will continue to
change.
The set time flashes again briefly as acknowledgement after a few seconds and is
then displayed permanently.
3. Press the temperature / time setting button . The left bar for the small temperature
level in the display (19) flashes.
4. Set the desired temperature level with the buttons
The set temperature level flashes again briefly as acknowledgement after a few
seconds and is then displayed permanently.
BEEM – Elements of Lifestyle
All manuals and user guides at all-guides.com
–
Level 1: Approx. 50°C – 60°C (left bar in the display
(19) lights up)
–
Level 2: Approx. 60°C – 70°C (left and middle bars in
the display (19) light up)
–
Level 3: Approx. 70°C – 85°C (all three bars in the
display (19) light up)
(The tea temperature varies depending on the fill level of
the tea pot)
and
. Pressing once adjusts
and
.
Seite/Page/Page/Página
20 / 49
Publicidad
Tabla de contenido
