Setting Surface Controls - IKEA CIRKULERA Manual

EN

Setting surface controls

The ability to heat food quickly and in large volumes
increases as the burner size increases. Your gas
appliance may be equipped with many different
sized surface burners.
It is important to select cookware that is suitable
for the amount and type of food being prepared.
Select a burner and fl ame size appropriate for the
cookware size.
• The standard size burner or burners may be
used for most surface cooking needs.
• Small burners are best used for low-fl ame
heating of small amounts of food.
• Large burners are best for bringing large
quantities of liquid to temperature or heating
larger quantities of food.
Setting a surface burner:
1. Place cooking utensil on center of surface burner
grate. Be sure the cooking utensil rests stable on
the burner grate.
2. Push the burner's surface control knob in and
turn counterclockwise out of the OFF position
(Figure 7).
3. Release the surface control knob and rotate to
the LITE position ( ). Visually check that the
burner has a steady gas fl ame.
4. Once the surface burner has a fl ame,
push the surface control knob in and turn
counterclockwise to the desired fl ame size
setting. Adjust the fl ame as needed using the
knob markings.
IMPORTANT
• NEVER place or straddle a cooking utensil over
two different surface cooking areas at the
same time unless the cookware is specifi cally
designed for the purpose.
• DO NOT cook with a surface control knob left
in the lite position ( ). The electronic ignitor
will continue to spark. Turn the control knob
out of the lite position and adjust the fl ame
size.
• Do not place aluminum foil, or ANY material
that can melt on the range cooktop. If items
melt, they may permanently damage the ap-
pearance of the cooktop
SETTING SURFACE CONTROLS
CAUTION
Do not place fl ammable items such as plastic wrap-
pings, spoon holders, or plastic salt and pepper
shakers on the cooktop when it is in use. These
items could melt or ignite. Potholders, towels, or
wooden spoons could catch fi re if placed too close
to the surface burners.
Figure 7: Surface control knob
NOTE
When setting a surface control knob to the lite
position, all of the electronic surface ignitors will
spark at the same time. However, only the surface
burner you are setting will ignite.
In the event of an electrical power outage, the
surface burners may be lit manually. To light a sur-
face burner, hold a lit match to the burner head,
then slowly turn the surface control knob to lite.
Once the burner ignites, push in and turn knob out
of lite then to the desired fl ame setting. Use cau-
tion when lighting surface burners manually.
15