Installing And Removing Flat Panel Display - PEERLESS SmartMount ST630P Instalación Y Ensamblaje

Installing and Removing Flat Panel Display

Attach display to tilt assembly (B). Tighten
3
M5 x 6mm screw (H) to lock display to tilt assembly.
Note: For security models, use security driver (I) to
tighten M5 x 6mm screws (H).
To remove display from mount, loosen screw (H)
and lift display off of mount.
WARNING
• Do not lift more weight than you can handle. Use ad-
ditional man power or mechanical lifting equipment
to safely handle placement of the display.
• Failure to lock hook plate (A) with screw (H) can
cause display to come off mount if hit accidentally.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
Adjust tension knob on right side of mount shown in
4
fi gure 4.1 to desired tension to balance your display
size and weight.
Push or pull from top or bottom of display to adjust
tilt as shown in fi gure 4.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display
from the bottom.
All manuals and user guides at all-guides.com
7 of 23
All other brand and product names are trademarks or registered trademarks of their respective owners.
DISPLAY
H
B
fi g. 3.1
TENSION KNOB
fi g. 4.1
ISSUED: 02-05-09 SHEET #: 201-9421-11 04-05-11
© 2011, Peerless Industries, Inc. All rights reserved.
A
Peerless Industries, Inc.
2300 White Oak Circle
Aurora, Il 60502
www.peerlessmounts.com