Ryobi TSS100L1 Manual Del Operador página 14

NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional
so that we can clearly show points being made in the
illustrations. Never operate the saw without all guards
securely in place and in good operating condition.
LOCKING / UNLOCKING THE SAW ARM
See Figure 9.
To unlock and raise the saw arm:
 Firmly grasp the "D" handle and apply downward
pressure while at the same time pulling the lock pin out
and away from the saw housing. Rotate lock pin 90º to
lock (or unlock) the saw arm.
 Release the lock pin and slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the "D" handle and apply downward
pressure while at the same time pulling the lock pin out
and away from the saw housing.
 Release the lock pin allowing it to lock the saw into place.
DUST BAG
See Figure 10.
A dust bag is provided for use on this miter saw. It fits over
the exhaust port on the upper blade guard.
NOTE: the exhaust port also accepts 1-1/4 in. vacuum hose.
To install:
 Squeeze the two metal clips to open the mouth of the
bag and slide it on the exhaust port.
 Release the clips. The metal ring in the bag should lock
in between the grooves on the exhaust port.
To remove the dust bag for emptying:
 Reverse the above procedure.
All manuals and user guides at all-guides.com
ASSEMBLY
14 — English
"D"
HANDLE
DUST
BAG
EXHAUST
PORT
LOCK
PIN
Fig. 9
Fig. 10