Ryobi TSS100L1 Manual Del Operador página 16

TO INSTALL / REPLACE THE BLADE
See Figures 14 - 15.
WARNING:
A 10 in. blade is the maximum blade capacity of the saw.
Never use a blade that is too thick to allow outer blade
washer to engage with the flats on the spindle. Larger
blades will come in contact with the blade guards, while
thicker blades will prevent the blade bolt from secur-
ing the blade on the spindle. Either of these situations
could result in a serious accident and can cause serious
personal injury.
 Unplug the saw.
 Remove screws. Rotate lower blade guard and blade bolt
cover up and back to expose the blade bolt.
 Depress the spindle lock button and rotate the blade bolt
until the spindle locks.
 Using the wrench provided, loosen and remove the blade
bolt.
NOTE: The blade bolt has left hand threads. Turn blade
bolt clockwise to loosen.
 Remove the flat washer and the outer blade washer. Do
not remove the inner blade washer.
 Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before
placing blade on spindle. Failure to do so could cause an
accident since blade will not tighten properly.
 Fit saw blade inside lower blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 15.
 Replace the outer blade washer and the flat washer.
Double "D" flats on blade washers align with flats on
spindle.
 Depress spindle lock button and replace blade bolt.
NOTE: The blade bolt has left hand threads. Turn blade bolt
counterclockwise to tighten.
CAUTION:
Always install the blade with the blade teeth and the
arrow printed on the side of the blade pointing down at
the front of the saw. The direction of blade rotation is
also stamped with an arrow on the upper blade guard.
 Tighten blade bolt securely.
 Replace the lower blade guard and blade bolt cover.
 Replace screws and tighten securely.
All manuals and user guides at all-guides.com
ASSEMBLY
16 — English
SPINDLE LOCK
BUTTON
NOTE: BEFORE USE,
REPLACE SCREWS AND
TIGHTEN SECURELY
TO PREVENT GUARD
MOVEMENT
TO
LOOSEN
FLAT
WASHER
BLADE
TO
BOLT
TIGHTEN
Fig. 14
OUTER
BLADE
WASHER
BLADE
BOLT
BLADE
INNER
BLADE
WASHER
SCREWS
LOWER
BLADE
GUARD
BLADE
BOLT
COVER
FLAT(S)
ON SPINDLE
INNER BLADE
WASHER WITH
DOUBLE "D"
FLATS
BLADE
OUTER BLADE
WASHER
WITH DOUBLE
"D" FLATS
Fig. 15