Sauder Whisker Manual Del Usuario página 15

STEP 10
å Fasten two EXTENSION RAILS (1) to the ENDS (J and Z).
Use six 1/2" FLAT HEAD SCREWS (16).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the 1st hole shown in the diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other
holes that line up with the holes in the ENDS. Turn a
SCREW into each hole.
Open end
1
st
Z
whiskersupport.com
1
Open end
1
16
1/2" FLAT HEAD SCREW
(6 used in this step)
429610
1
st
1
st
1
J
Open end
Page 15