Maintenance And Service - DeLonghi MG15E Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GB
31-01-2002
14:40
Pagina 6
4- To set programme B, press the "
above to select the start hours and minutes. The set time will be the same as for
the first programme. When the operating time is changed, the time of both pro-
grammes is updated
5-- Use the "+" or "-" buttons to set the desired comfort temperature, as described
above.
6-When set in this way the appliance will automatically switch on at the set time and
automatically maintain the preset comfort temperature. To cancel a programme,
press the "
AUTO" button and then the "hour" and "min" buttons until the
display shows (see Fig.)
TIMER OVERRIDE
To operate the appliance without using the programmes (timer), press the "ON
MODE" button (Fig.5). The yellow lamp will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does
not switch on. The display shows the blinking numbers.
To switch it on, repeat the above described operations.
WARNINGS
You must leave the heater plugged in at the mains socket to keep the heaters memory
programmed.
If the heater looses its electricity supply for more than 2 minutes, e.g. switched off at
the mains socket or in the event of a power failure, the heater's programmes will be
lost, and the heater will not work until reset.
A safety device switches the heater off in the event of overheating. To restart the
heater, call the nearest Service Center to change the safety device.
Note: when the safety device intervenes, the heater doesn't heat but the display regu-
larly works.

4. MAINTENANCE AND SERVICE

Always remove the plug from the power socket and allow the radiator to cool. Wipe
radiator with a soft damp cloth, do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, wind the cable round the
holder and store it in a dry place (see fig. in front page).
This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may result
in fire hazard or electric shock.
Call the nearest Service Center (see attached list of Service Centers).
6
All manuals and user guides at all-guides.com
AUTO" button again and then proceed as
:

Publicidad

Tabla de contenido
loading

Tabla de contenido