MSA Advantage 900 Instrucciones página 10

Align tabs on facepiece and yoke Snap yoke into place
CARTRIDGES
The exterior of the cartridge body can be wiped down using a cloth with Confidence Plus 2 Cleaner.
Subsequently, wipe the cartridge body with clean water using a damp cloth. Following the manufacturer's
instructions, care must be taken to ensure that neither the liquid disinfectant solution nor the water
touches the surface of the filter media itself.
CAUTION
Cleaning and Disinfecting at or below 110ºF temperature will avoid possible overheating and
distortion of parts which would require replacement.
MAINTENANCE
This respirator must be kept in good condition to function properly. When any respirator shows evidence
of excessive wear or damage, it must be replaced immediately. Refer to the Preparations for Use section
for proper inspection of the respirator. This respirator, when not in use, should be stored in a clean, dry
location, such as its storage bag. Do not distort rubber facepiece during storage. When disposing of of
the respirator or its components, do so in accordance with local, state, and federal regulations.
10
TAL 122 (L) Rev. 0 - 10218530