Surface Light Replacement - IKEA VALSKAPT Manual

CLEANING AND CARE
Disconnect the power cord or leave the door open to deactivate the oven during cleaning.
Disconnect the power cord before replacing filters and lights.
Cleaning the exhaust filters
The oven ventilation exhaust filters should be
removed and cleaned often; generally at least once
every month.
Vent exhaust filter part number 5304478913
To order parts call 833-337-4006
CAUTION
To avoid risk of personal injury or property damage, do not operate
oven hood without filters properly in place.
BOTTOM VIEW
Grease filter
1. To remove the exhaust ventilation filters, slide the
filter to the rear. Then pull filter downward and
push to the other side. The filter will drop out.
2. Soak the ventilation filters in hot water using a
mild detergent. Rinse well and shake to dry or
wash in a dishwasher. Do not use ammonia. The
aluminum on the filter will corrode and
darken.
3. To reinstall the exhaust ventilation filter, slide it
into the side slot, then push up and toward oven to
lock. Reinstall the 2nd filter using the same
procedure.
24
(Front of microwave oven)
Surface lights
(Rear of microwave oven)

Surface light replacement

CAUTION
To avoid risk of personal injury or property damage, wear gloves
when replacing the light bulbs.
1. Unplug the microwave oven or turn off power at
the main circuit breaker.
2. Remove the LED light cover mounting screws at
both light positions under the microwave.
3. Remove the LED light mounting screw.
4. Unplug the LED light from the harness, replace
with LED light of part# 5304499540. To order
parts call 833-337-4006. Then reconnect the
harness.
5. Re-install LED light and mounting screw. When
re-installing mounting screw be careful not to
damage the LED light.
6. Re-install LED light cover and mounting screw.
7. Plug the microwave back into the power supply or
turn the power back on at the main circuit
breaker.
EN