Indesit H151 WH Instrucciones De Uso página 11

Installation
Assembly
GB
Remove the metal grille before beginning assembly,
this will make it easier to manoeuvre the apparatus
(see section "cleaning the grease filters" section in the
"Maintenance" chapter for instructions).
1) Drill a hole in the wall for an air outlet (with a
diameter of 133mm) as per the Diagram below
which shows the measurements for the various
possible situations.
Ø133
min650
2) Some models are fitted with an upper air vent (B)
and a rear air vent (A) closed by a plate that must
be removed if you wish to use it. Fit the flange (C)
on the vent used; if you use the rear vent, close the
upper one with the cap (E) to be ordered from your
dealer.
Some models are fitted with 2 air vents, one in the
upper part (B) and one at the rear (A), which you
can use as required. Fit the flange (C) on the vent
used and close the other one with the cap (E).
10
85
min
940
720
C
B
A
E
3) Wall mounting
a) Make 4 holes in the wall following the
measurements shown in the diagram below and
insert the plugs.
Ø 8mm
A
=
min650
MODELS
50cm
60cm
90cm
b) Take 2 of the supplied screws (G) and insert
them into the plugs without tightening them
completely.
c) Hang the hood onto the 2 screws and tighten the
2 screws to the wall working from inside the
apparatus.
d) Complete final fixing by inserting the other 2
screws (H).
H
=
44
732
A X
44cm 41cm
54cm 51cm
84cm 81cm
G