Indesit H151 WH Instrucciones De Uso página 12

4) Assembly on a wall unit
a) For installation with an air outlet at the top (B),
drill a 133mm diameter hole onto the wall unit
before assembly.
Ø 133
B
b) Drill 4 holes onto the wall unit using the
measurements shown in the diagram below.
Fix the hood onto the 4 screws working from
inside the wall unit.
Ø 6mm
=
5) Connect a flexible pipe to the hood flange using a
metal clamp. Piping and clamps are not supplied.
85
256
34
X
=
6) MAKE SURE THAT THE DUCTING/FILTERING
LEVER IS IN THE CORRECT POSITION: this lever
is located on the motor unit and must be positioned
on the (P) symbol for installing the ducting version.
P
7) Wire the hood using the power supply cable (see
section on "Electrical connection").
GB
11