Ivoclar Vivadent Programat CS2 Guía Rápida página 4

1. Installation
Remove the furnace components from their packaging and place the
unit on a suitable table. Please observe the instructions on the outer
packaging. Make sure the voltage indicated on the rating plate com-
plies with the local power supply. If this is not the case, the furnace
must not be connected.
Mounting the cooling tray
A
Remove both screws for the cooling tray (1).
Place the cooling tray (2) on the frame plate (3).
B
Make sure that the cooling tray is correctly positioned on the
frame plate.
Secure the cooling tray with the two screws (1).
C
D Placing the firing plate
The firing plate (4) can now be placed on the firing plate holder (5).
Mounting the furnace head
E
The furnace head is best mounted with the back of the furnace pointing
towards the user. Lift the furnace head with both hands as shown in the
picture and place it on the furnace head mounting.
Mount the furnace head as shown in the picture until you feel it click
F
into place. Make sure that neither the firing plate nor the insulation is
damaged during the mounting of the furnace head.
All manuals and user guides at all-guides.com
A
1 1
C
1
E
B
2
3
D
4
2
F
5