5.
Remove the 15 Amp fuse from the fuse holder located
behind the battery panel.
6.
Disconnect the negative (-) cable at the battery.
7.
Disconnect the positive (+) cable at the battery.
8.
Remove the battery and install replacement battery.
DON'T POLLUTE. CONSERVE RESOURCES.
RETURN USED BATTERY TO RECYCLING
COLLECTION CENTER.
9.
Connect the positive (+) cable at the battery.
10. Connect the negative (-) cable at the battery.
11. Install the 15 Amp fuse into the fuse holder.
12. Install the battery panel.
13. Close and lock the roof.
14. Restore utility power to the generator.
15. Push the ON/OFF Switch on the back of the generator to
the "ON" (I) position.
16. Set the generator mode to AUTO.
Charging the Battery
If it is necessary to charge the battery, proceed as follows:
1.
Push the ON/OFF Switch on the back of the generator to
the "OFF" (0) position.
2.
Remove utility power to the generator to de-energize the
battery charger.
36
3.
Unlock and open the roof as described in the Access
Panels section of this manual.
4.
Remove the battery panel.
5.
Remove the 15 Amp fuse from the fuse holder located
behind the battery panel.
6.
Disconnect the negative (-) cable at the battery.
NOTICE: Failure to disconnect negative battery cable could
result in equipment failure. DO NOT attempt to jump start
the generator. Damage to equipment resulting from failure to
follow this instruction will void engine and generator warranty.
7.
Charge battery with the battery charger at 2 Amps until
the battery holds 12 Volts. DO NOT exceed 13.7 volts
when charging the battery.
NOTICE: DO NOT use a battery booster to quick charge a
low battery.
8.
Connect the negative (-) cable at the battery.
9.
Install the 15 Amp fuse into the fuse holder.
10. Install the battery panel.
11. Close and lock the roof.
12. Restore utility power to the generator.
13. Push the ON/OFF Switch on the back of the generator to
the "ON" (I) position.
14. Set the generator mode to AUTO.
BRIGGSandSTRATTON.COM