Grease Filter - Gorenje S3 IHGC963ORAB Manual Del Usuario

Press again to turn off the hood (OFF).
Note:
manual selection excludes any other suction related set function.
T5. ON/OFF Intensive suction speed
Note:
After 5 minutes of operation the hood returns to its previous state.
T6*. (Only certain models ON/OFF intensive suction speed
Note:
After 5 minutes of operation, the hood goes back to the previous status.
T7. ON/OFF
operation mode
Every 50 minutes of inactivity, the suction speed (power 1 is turned on for 10 minutes.
T8. ON/OFF Delayed switch off of the suction speed
Note:
this function is available for the speeds that can be selected with button
T9. Indicator and reset filter saturation
The button lights on automatically with steady light when it is necessary to perform the grease filter mainte-
nance. The button lights on automatically with flashing light when it is necessary to perform the charcoal filter
maintenance.
After performing the maintenance, with the hood off and the button active, press the button for more than 3
seconds to perform the reset of the filter saturation indicator; repeat the operation if necessary (for ex., when
both filters are saturated).
Activation of the charcoal filter saturation indicator
The saturation indicator of the charcoal filter is normally disabled. To activate it, proceed in the following man-
ner:
With the display on (ON) and the suction off (OFF), press simultaneously the buttons
3 seconds; the button
To disable it, repeat the operation; the button
Setting of Automatic Operation parameters
For correct use of the automatic operation, perform "Hood Calibration".
Hood Calibration
With the display on (ON) and the suction off (OFF), press button
The suction speed (power) 1 starts functioning and button
it will last for approx. 5 minutes.
Note:
to interrupt the calibration, press
be repeated.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by
switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the
socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out mainte-
nance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do
not use abrasive products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the
filters may cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all
responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to ob-
serve the above safety recommendations.

Grease filter

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive detergents,
either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in
a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the
grease filter, pull the spring release handle.
EN 30
(power)
"Refresh".
T9
lights on with steady light for approx. 5 seconds, to indicate the activation.
T3
for 5 seconds; the calibration will be invalidated and should therefore
„POWER BOOST"
(timed)
(power)
(power) (approx. 30 minutes
T9
will flash for approx. 5 seconds to indicate the disabling.
T3
for 3 seconds.
T3
flashes to indicate that hood calibration is initiated and
„POWER BOOST x 2"
T4
.
T8 T9
and
(timed)
for more than