7�4 Installing The Sanding Disc; 7�5 Operating The Tool - AmazonBasics B087RJK3GQ Manual Original

EN
A minimum length of 0�39" (10 mm) of the
shaft must be inside the collet nut for safe
operation�
0�39" (10 mm)
O/P
2� Place the small wrench on the spindle (H)
to stop it from rotating and hold it in
place�
3� Use the large wrench to fully tighten the
collet and grip the stone in position by
turning it clockwise until secure�
Small wrench
7.4 Installing the sanding disc
1� Refer to chapter 'Installing and removing
the collet to install the larger collet and
then insert the shank (V) into the collet�
2� Place the smaller wrench on the spindle
(H) to stop it from rotating�
14
G
Large wrench
3� Use the larger wrench to fully tighten the
collet and grip the shank (V) in position�
4� Screw the disc holder (F/U) onto the
shank (V)�
5� Tighten the nut on the shank (V) against
the disc holder (F/U) using the small
wrench�
V
F/U
6� Screw the chosen sanding disc onto the
disc holder (F/U)�
F/U
Sanding disc
7.5 Operating the tool
CAUTION
Risk of injury!
» The air tool will continue to rotate for
a short time after the trigger has been
released�
» Do not put the tool down until the
accessory have stopped rotating�