1�6 Accessory Hazards; 1�7 Workplace Hazards; 1�8 Dust And Fume Hazards - AmazonBasics B087RJK3GQ Manual Original

1.6 Accessory hazards
» Disconnect the die grinder from the
energy supply before fitting on changing
the inserted tool or accessory�
» Use only sizes and types of accessories
and consumables that are recommended
in this user manual; do not use other
types or sizes of accessories or
consumables�
» Avoid direct contact with the inserted tool
during and after use as it can be hot or
sharp�
» Never mount a grinding wheel, cut-off
wheel or router cutter on a die grinder� A
grinding wheel that bursts can cause very
serious injury or death�
» Do not use mounted wheels which are
chipped or cracked or which could have
been dropped�
» Use only permitted inserted tools of the
correct shaft diameter�
» Pay special attention to the fact that the
permitted speed of the mounted point
has to be lowered due to the increase
of the length of the shaft between the
end of the collet and the mounted point
(overhang)� Make sure that the minimum
gripping length of 0�39" (10 mm) is
observed�
» Be aware of the risk of mismatching the
diameter of the shaft of the mounted
point and that of the collet�
1.7 Workplace hazards
» Slips, trips and falls are major causes
injury when using this tool� Be aware of
slippery surfaces caused by use of the
tool and also of trip hazards caused by
the air line or hydraulic hose�
» Proceed with care in unfamiliar
surroundings� There can be hidden
hazards, such as electricity or other utility
lines�
» The die grinder is not intended for use in
potentially explosive atmospheres and is
not insulated against contact with electric
power�
» Ensure that there are no electrical cables,
gas pipes, etc�, which can cause a
hazard if damaged by use of the tool�
1.8 Dust and fume hazards
» Dust and fumes generated when using
die grinders can cause ill health (for
example cancer, birth defects, asthma
and/or dermatitis); risk assessment and
implementation of appropriate controls
for these hazards are essential�
» Risk assessment should include dust
created by the use of the tool and the
potential for disturbing existing dust�
» Operate and maintain the die grinder as
recommended in this user manual, to
minimize dust or fume emissions�
» Direct the exhaust so as to minimize
disturbance of dust in a dust-filled
environment�
» Where dust or fumes are created, the
priority shall be to control them at the
point of emission�
» All integral features or accessories for
the collection, extraction or suppression
of airborne dust or fumes should
be correctly used and maintained in
accordance with this user manual�
» Select, maintain and replace the
consumable/inserted tool as
recommended in this user manual, to
prevent an unnecessary increase in dust
or fumes�
» Use respiratory protection in accordance
with the employer's instructions and
as required by occupational health and
safety regulations�
» Working in certain materials creates
emission of dust and fumes, causing a
potentially explosive environment�
EN
5