Important Safeguards; 1�1 General Safety - AmazonBasics B087RJK3GQ Manual Original

1. Important Safeguards

WARNING
accessories on, or working near the die
grinder� Failure to do so can result in serious
bodily injury�
WARNING
» The warnings, precautions, and
instructions discussed in this user
manual cannot cover all possible
conditions and situations that may
occur� The operator must understand
that common sense and caution are
factors which cannot be built into
this tool, but must be supplied by the
operator�
Read the Material Safety Data Sheets
(MSDS) before working on any materials�
Contact the suppliers of the workpiece
materials and abrasive materials for copies
of the MSDS if one is not readily available�
For multiple hazards,
read and understand
the safety instructions
before installing,
operating, repairing,
maintaining, changing
MSDS MSDS MSDS
WARNING
Risk of serious personal
injury!
» Exposure to dust generated from
workpiece and/or abrasive materials
can result in lung damage and/or skin
irritation (dermatitis)�
» Use dust capture or local exhaust�
Wear appropriate personal protective
equipment (PPE)�
WARNING
Risk of injury!
» The rated speed of the accessories
must be at least equal to the maximum
speed marked on the die grinder�
Accessories running faster than their
rated speed can break and fly apart�
» The arbour size of any accessory must
properly fit the spindle or collet of the
die grinder� Accessories that do not
match the mounting hardware of the
die grinder will run out of balance,
vibrate excessively and may cause loss
of control�
1.1 General safety
» Only qualified and trained operators
should install, adjust or use the die
grinder�
» Do not modify this die grinder�
Modifications can reduce the
effectiveness of safety measures and
increase the risk to the operator�
» Do not discard the safety instructions;
give them to the operator�
» Do not use the die grinder if it has been
damaged�
» Always ensure that shaft diameters match
internal diameters of the collet inserts�
» Do not operate tool in water or in an
excessively wet application�
» Do not use abrasive accessories with a
lower RPM rating than this marked on the
tool�
» Do not leave an unattended tool
connected to air source�
EN
3