10�2 Maintenance; Cleaning And Maintenance; 10�1 Cleaning; Daily Maintenance - AmazonBasics B087RJK3GQ Manual Original

Problem
Tool runs slowly� Low
air pressure�

10. Cleaning and Maintenance

WARNING
Risk of injury!
» Make sure that the air tool is
disconnected from the air supply
before starting any cleaning or
maintenance procedures�
10.1 Cleaning
» Keep the body of the tool clean and free
from excessive oil and debris by wiping
with a cotton rag�
» Grit or gum deposits inside the tool may
also reduce its efficiency� This condition
can be corrected by cleaning out the air
strainer and flushing out the tool with
gum solvent or oil�
Possible cause
» Motor parts jammed
with dirt or gum
deposits
» General airflow
blocked by dirt�
» Moisture or
obstruction in air
hose�
» Regulator set to low
pressure�
» Improper size of air
transmission lines,
hoses, fittings, or
quick-connectors�
Strainer
Solution
» Examine air filter on the compressor
and air inlet strainer for cleanliness�
» Operate the tool in short bursts�
» Air supply must be clean and dry�
Clean out air hose(s) and remove
any kinks or bends�
» Adjust the pressure at the regulator
to max� 90 PSI (6�2 bar)� Check
for loose connections at air inlet,
o-rings, etc�
» Use appropriate-sized air lines/
hoses� Verify proper fittings/quick-
connectors�
» Never use corrosive detergents, wire
brushes, abrasive scourers, metal or
sharp utensils to clean the tool�
» Check the air inlet strainer frequently for
blockage and clean if necessary�
10.2 Maintenance
WARNING
» This air tool should be inspected
periodically to make sure it is in a safe
working condition�
Regular maintenance ensures the air tool
operates in a safe and working condition�

10.2.1. Daily maintenance

» Drain water from the air tank, air line and
compressor before each use of the air
tool�
» Pour a few drops of air line oil into the
air inlet� This should be carried out
regardless of whether or not an in-line
lubricator is used�
» If an in-line lubricator is not used, this
procedure should be repeated after every
two to three hours of use�
EN
17