7�6 Disconnecting The Air Hose; Sanding And Grinding Tips - AmazonBasics B087RJK3GQ Manual Original

NOTICE
» Tool speed can be adjusted by
increasing or decreasing the pressure
on the trigger or by adjusting the air
regulator wheel (L) until the you reach
the desired speed�
» Do not use excess pressure while using
the grinding stone as this will shorten
its life�
1� Use your index finger to slide the safety
latch forward while squeezing the
trigger (N)�
Locking lever
Trigger
2� Release the trigger to stop the air tool�
7.6 Disconnecting the air hose
NOTICE
Do not disconnect the air
supply hose until the compressor has
been shut down and the compressed air
released�
1� Refer to the compressor instruction
manual for the procedure to shut down
and release the compressed air�
2� Once the pressure has been released,
disconnect the air supply hose from the
air inlet (M)�

8. Sanding and Grinding Tips

» Do not force the sanding disc or stone
against the material being worked on�
» The key to efficient grinding is to control
the pressure and surface contact
between the grinding tool and the
workpiece�
» Allow the tool to reach full speed before
working on a workpiece�
» Avoid overloading the grinder� If it
becomes hot during use, rest for a few
minutes while it cools down�
EN
15