Installation Instructions - Teka RVU 20046 GBK Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

 Before Using Your Wine cooler



Remove the exterior and interior packing.



Before connecting the Wine cooler to the power source, let it stand upright for approximately 2 hours.

This will reduce the possibility of a malfunction in the cooling system from handling during

transportation.



Clean the interior surface with lukewarm water using a soft cloth.



When disposing your appliance, please choose an authorized disposal site.

 Installation of Your Wine Cooler



This appliance is designed to be for free standing installation or built-in (fully recessed) (Refer to

sticker location the back of this appliance).



This appliance is intended to be used exclusively for the storage of wine or beverages.



Place your Wine cooler on a floor that is strong enough to support it when it is fully loaded. To level

your Wine cooler, adjust the front leveling leg at the bottom of the Wine cooler.



This appliance is using flammability refrigerant.So never damage the cooling pipework during the

transportation.Locate the Wine cooler away from direct sunlight and sources of heat (stove, heater,

radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.



Avoid locating the unit in moist areas.



Plug the Wine cooler into an exclusive, properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an authorized

Products service center.

 Attention



Store wine in sealed bottles;



Do not overload the cabinet;



Do not open the door unless necessary;



Do not cover shelves with aluminum foil or any other shelf material which may prevent air

circulation;



Should the Wine cooler be stored without use for long periods it is suggested, after a careful

cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible

formations of condensation, mold or odors.

 Ambient Room Temperature Limits

This appliance is designed to operate in ambient temperatures specified by its temperature class marked

on the rating plate.

Class

Extended Temperate

Temperate

Subtropical

Tropical

Replaceable (LED only) light source by a professional

This product contains a light source of energy efficiency class G.