Sony VPL-HS1 Manual De Instrucciones página 15

To view the picture Press
from INPUT to
display
Video equipment VIDEO 1
connected to VIDEO
INPUT on the projector
Video equipment S-VIDEO 1 AUDIO INPUT
connected to S VIDEO
INPUT on the projector
RGB/component INPUT A
equipment connected to
PJ MULTI INPUT via
the optional signal
interface cable or the
interface unit
Video equipment VIDEO 2
connected to PJ MULTI
INPUT via the optional
signal interface cable or
the interface unit
Video equipment S-VIDEO 2 PJ MULTI
equipped with S VIDEO
connected to PJ MULTI
INPUT via the optional
signal interface cable or
the interface unit
"Memory Stick"
MS
inserted into the
"Memory Stick" slot
*
Set the INPUT-A setting in the SET SETTING
according to the input signal. (1 page 20)
5
Move the zoom lever to adjust
the size of the picture.
Sound is
heard from the
equipment
connected to
AUDIO INPUT
*
PJ MULTI
INPUT
PJ MULTI
INPUT
INPUT
AUDIO INPUT
menu
Zoom lever
6
Move the focus lever to adjust
the focus.
Adjust to obtain sharp focus.
7
Press VOLUME + or – to adjust
the volume.
VOLUME
+
–
To turn off the power
1 Press the [/1 (on/standby) switch.
A message "Power OFF?" appears on the screen.
2 Press the [/1 switch again.
The ON/STANDBY indicator flashes in green and
the fan continues to run to reduce the internal heat.
Also, the ON/STANDBY indicator flashes quickly
during which you will not be able to light up the
ON/STANDBY indicator with the [/1 switch.
3 Unplug the AC power cord from the wall
outlet after the fan stops running and the
ON/STANDBY indicator lights in red.
You can turn off the projector by holding the [/1 (on/
standby) switch for about one second, instead of
performing the above steps.
Projecting the Picture on the Screen
Focus lever
15
GB