Setup Requirements; Charging The Parent Unit (9 Hours) - Angelcare AC510 Manual De Usuario

side facing up. The sensitivity level may also need to be adjusted. Refer
to Step 5.1. Always be sure to immediately check on baby whenever an
alarm sounds.
12.20 Sensor Pad ‑ Your Sensor Pad can be used in any cot that is stationary.
If the cot has a spring or slat base, place a hard board between the cot base
and the Sensor Pad measuring at least 33 x 33 cm and 6 mm thick. Only
use your Angelcare ® monitor in a stationary sleeping environment such
as a cot where the Sensor Pad can rest on a completely flat, firm surface.
The Sensor Pad is made of plastic and does not permit the air to circulate.
Therefore, mildew build up could develop underneath the mattress in the Sensor
Pad area. We suggest rotating the mattress regularly to prevent any mildew.
13. IMPORTANT SAFETY INSTRUCTIONS RELATED TO USE OF BATTERIES
13.1 Use ONLY the type and size of battery specified in the owner's manual.
There is a risk of explosion if battery is replaced with an incorrect type.
13.2 Charge the battery for 9 hours prior to first use. Be sure to have the
monitor in the OFF position during this period. ONLY use the adapters
included with your monitor.
13.3 DO NOT use these adapters with any other equipment.
13.4 When unplugging the adapter from the Camera, be sure it is switched
to the OFF position.

SETUP REQUIREMENTS

INCLUDED:
Touchscreen Parent Unit
(for Parent Unit and Camera)
STEP 1 ‑ CHARGING THE PARENT UNIT (9 HOURS)
Battery compartment lock
2
All manuals and user guides at all-guides.com
Camera
2 x AC adapter
1
Rear View
13.5 DO NOT dispose of batteries in fire. They may explode. Check with
local regulations for possible special disposal instructions.
13.6 Exercise care in handling batteries in order not to short out the
batteries with conducting materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging, mutilation, or incineration
of batteries must be avoided to prevent one or more of the following
occurrences: release of toxic materials, release of hydrogen and/or oxygen,
gas and rise in surface temperature.
13.7 DO NOT attempt to rejuvenate the battery provided with or identified
for use with this product by heating them. Sudden release of battery
electrolyte may occur, causing burns or irritation to eyes or skin.
13.8 If and when necessary, the battery must be replaced with identical
new ones or equivalent (volts and size).
13.9 Remove the battery from the Parent Unit if you store the product
over 30 days because the battery could leak and damage the product.
13.10 Discard 'dead' batteries as soon as possible since 'dead' batteries
are more likely to leak in a product. If a battery has leaked or vented, it
should be replaced immediately using protective gloves.
13.11 DO NOT store this product, or the battery provided with or identified
for use with this product, in high‑temperature areas.
Model AC510
Baby Video and Sound Monitor
Tabletop stand with
removable wall
mount metal ball
(for Camera)
Lithium ion battery pack
(for Parent Unit)
1) Unlock the battery compartment
on the rear and remove the
cover. Insert the provided
rechargeable battery into the
compartment. Contacts of the
battery and the contacts in the
compartment must be aligned.
2) Connect the USB plug to the
Parent Unit and connect the
power adapter with an electrical
outlet.
3) Charge the unit for 9 continuous
hours prior to first use.
E
N
Hardware
(Screwdriver
required
for wall mounting)
51