Setup Requirements; Step 1 - Installing The Sensor Pad - Angelcare AC300-A Manual Del Usuario

SETUP REQUIREMENTS

INCLUDED:
6
Nursery Unit 1 Sensor Pad with pre-installed cord covers
YOU MUST PREPARE:
One hardboard (not included)
Thickness: 1/4'' (6 mm)
Minimum dimensions:
13'' x 13'' (33 cm x 33 cm)
Maximum dimensions:
Hardboard
equal to the mattress size
IMPORTANT
The hardboard must be larger than
the Sensor Pad surface area.
IMPORTANT
BABY'S ROOM:
Place the crib near a supporting wall and far from air
currents. Install the Nursery Unit on a flat, stable surface
facing the crib at a distance of at least 3 feet (0.9 meter).
6
5
Sensor Pad
6
MOVEMENT MONITOR
Model AC300-A
3 2 1
4
5
WHAT YOU WILL NEED (NOT INCLUDED):
2X
2 AA Alkaline
Miniature Philips
Batteries Screwdriver
IMPORTANT
Keep
at least
3 ft.
(1 m)
4 3 2 1

STEP 1 - INSTALLING THE SENSOR PAD

3 2
4
5
6
Sensor Pad with pre-installed cord covers
WARNING
STRANGULATION HAZARD.
Children have STRANGLED in cords.
• Because of the serious strangulation risk to infants
and toddlers, parents and caregivers should never
place the Nursery Unit within 3 feet (0.9 m) of a crib.
• NEVER use Sensor Pad without the cord covers.
Check cord covers before each use to ensure it is
securely placed under the leg of the crib. Discontinue
use of Sensor Pad if any cord covers are damaged or
broken.
1.1 - SELECT A LOCATION FOR THE NURSERY UNIT
Select a location for the Nursery Unit that is at least
3 feet (0.9 meter) away from the crib.
6
5
Sensor Pad
Cord covers 1, 2, 3, 4:
Position on floor
1
Cord cover 4:
Contains double sided
tape to securely install
beneath crib leg
Cord cover 5:
Position vertically
between mattress
support and floor
Cord cover 6:
Place under
the mattress
IMPORTANT
Keep
at least
3 ft.
(1 m)
4 3 2 1
E
N
7