Technical Data; General Warnings; Correct Usage - Rupes LH31N Instrucciones Original De Uso Y Manutención

TECHNICAL DATA

TYPE
INSULATION CLASS
ABSORBED POWER
ELECTRONIC OVERLOAD PROTECTION
ELECTRONIC SPEED CONTROL
ROTATION RPM
MECHANICAL SPEED CONTROL
ABRASIVE DISC DIAMETER mm
BUFFER DIAMETER MAX mm
SPINDLE THREAD
according to EPTA-Procedure 01/2003
WEIGHT Kg
(*) The tool must be connected to a suitable dust extraction system (not supplied).
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may
vary. Refer to the label technical specifications to the nominal values of the tool.

GENERAL WARNINGS

The safety and accident prevention instructions are reported in
the "SAFETY INSTRUCTION" booklet which forms an integral part
of these documents. This OPERATING INSTRUCTIONS MANUAL
indicates the additional information required specifically for use
of the tool.

CORRECT USAGE

This tool is designed to be used as a polisher. Read all the
warnings, instructions, indications provided on drawings and
specifications supplied with this tool. Failure to comply with all the
instructions provided below may cause electrical shocks, fires and/or
serious injuries.
This tool is not intended to be used for smoothing, metal
brushing and cutting operations. The use of this tool for unintended
applications may cause hazards and injuries to people.
The tool must be used with accessories that have been
specifically designed or recommended by the manufacturer. The
fixing of the accessory to the tool does not guarantee a safe
operation.
The rated speed of the accessories must be at least equivalent to
8
LH232N
1200 W
NO
NO
1600÷3400
YES*
178
200
M14
3,7
the maximum speed specified on the tool. Using the accessories
at speeds above the rated one, may cause them to break or be
projected into the air.
The external diameter and thickness of the accessories must
match the specifications of the tool. Accessories with incorrect
dimensions cannot be adequately protected or controlled.
The configuration of accessories must match the tool. The use of
accessories that cannot be perfectly fitted on the tool may result in
imbalance, excessive vibrations and in the impossibility of controlling
the tool.
Do not use damaged accessories. Before use, inspect all the
accessories. Inspect the supporting pads and verify there are no
cracks, tears or excessive wear. If the tool or accessory has
fallen, verify that it is not damaged or install a new accessory.
After inspecting or installing an accessory, test the operation of
the tool at maximum speed and without load for one minute,
keeping at a safety distance. If the accessories are damaged, they
will break during this test.
ENGLISH
LH31N LH32EN
II II
1200 W 1200 W
NO YES
NO YES
3400 1400÷3400
NO NO
178 178
— —
M14 M14
3,3 3,3
8
II