Parts And Components; Before Use; Operation - cecotec SURFACE PRECISION 9700 SMARTH HEALTHY Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
1. Display
2. Right foot contact area
3. Left foot contact area
4. High-precision sensor
5. Battery cover
6. Body-measuring tape

2. BEFORE USE

Take the product out of the box. Check carefully if there is any damage, and if there is,
immediately notify the Technical Support Service of Cecotec.
Remove the protective strip from the battery compartment, located on the bottom part of the
device, in order to activate it. This protective strip is placed for a more secure transportation.
Further information
Weight yourself without any clothing and barefoot.
It is suggested to weigh yourself at the same time and always under the same circumstances.
Measured values might be distorted if weight is measured immediately after doing sport or if
you have not eaten or drunk enough over the day.
Measurement of body fat, water content and muscle and bone mass is only possible with bare
and dry feet.
The scale reacts to a minimum weight of 5 kg and rounds up weight to whole 100 g.
Measuring surface must be clean in order to work properly.

3. OPERATION

Normal mode
Place the device on a solid, dry and flat surface (avoid carpets). Uneven floors will result in
inaccurate measurement results.
Tap your foot on the scale in order to activate the display.
Wait until display shows '0.0' (kg/lb/st).
Before standing on the scale, select unit of measure: kg, lb or st. See the Measuring unit setting
section.
Stand on the scale, the device will star calculating weight.
Once the weight has been established, the number on the display will flash. You can now get
26
SURFACE PRECISION 9700 SMARTH HEALTHY / 9750 SMARTH HEALTHY