For Your Safety - Würth Master WDM 101 Instrucciones Para El Manejo

All manuals and user guides at all-guides.com
WDM 101 - Buch Seite 14 Dienstag, 8. Januar 2008 1:36 13
GB
Working safely with the
measuring tool is possible
only when the operating
instructions and the safety
notes are read completely and the instruc-
tions contained therein are strictly followed.
Save these instructions and hand them over
to other persons before allowing them to
operate the device.
This measuring tool uses class 2 laser irradia-
tion in accordance with IEC 60825-1: 2007.
This can cause you or other persons to be
unintentionally blinded.
The device meets the requirements for electro-
magnetic compatibility (EMC). Interference of
other equipment/devices within the vicinity of
the Laser Distance Meter is not excluded when
these are not sufficiently shielded against
radio frequency signals. Observe the safety
information of such equipment/devices.
The symbols used have the following mean-
ing:
DANGER:
Operational danger or improper usage that
can lead to serious personal injury or death.
CAUTION:
Operational danger or improper usage that
can lead to minor personal injury, but cause
major material damage, financial loss or
environmental damage.
Danger of blinding by the laser
beam.
Do not look into the laser beam and
do not aim the beam at other persons
or animals.
DANGER:
Do not look into the laser beam and do
not unnecessarily aim the beam at other
persons or animals. The natural corneal
reflex is not a sufficient protective measure.
14

For Your Safety

Do not look into the laser beam with op-
tical aids, such as, e. g., binoculars. Opti-
cal aids can focus the laser beam in a dan-
gerous manner for the eye.
Do not mistake laser viewing glasses with
laser protection glasses. They are used
only for better viewing of the laser beam in
bright light.
Do not make the type plate on the device
unrecognisable. Missing information of
the laser class can lead to careless han-
dling of the device on behalf of the user.
Keep the device out of the reach of chil-
dren. They can cause danger to themselves
and to others.
Never open the device yourself. The laser
beam is dangerous for the eyes. Have
damages repaired only through an author-
ized Würth customer service agent.
CAUTION:
Do not aim the device into the sun. Aim-
ing directly into the sun can cause damage
to the sensor.
Do not drop the device. The device can be-
come damaged and deliver incorrect
measured values. Perform check measure-
ments before carrying out important meas-
uring tasks, and inspect the function of the
stops/rests. Pay attention to cleanness of
the laser optics.
Protect the device against moisture. Pene-
trating moisture damages the electronics.
Always store and transport the device in its
protective case.
Other optical equipment/devices can be
subject to disturbance due to reflected dif-
fused light. Check if any other optical
equipment/devices are in the vicinity.
Use only original Würth accessories. Us-
age of accessories that are not recom-
mended can lead to incorrect measured
values.